SWITCH GEAR | CONTROL PANEL
360 International designs and builds NEMA compliant enclosed, load sharing switch gear and lineups for use with diesel and/or natural gas generator packages.
Switch gear come with:
-
Interior and exterior ANSI 61 powder-coat paint finish.
-
Top or bottom control cable entries with termination paths accessible from front or rear.
-
Copper main bus, insulated or non-insulated, standard or custom, KAIC bracing, ground bus, etc.
-
All equipment in accordance to applicable NEMA/ANSI code and guidelines.
Class 1, Div. II & Non-classified
Ranging from 25kW to 25MW
Available in 50 or 60 HZ
Switch Gear & Control Panel Gallery




Additional Information:
-
Non-classified and Class 1 Div II stand-alone generator control panels.
-
Non-classified and Class 1 Div II stand-alone compressor control panels.
-
Non-classified and Class 1 Div II stand-alone pump control panels.
-
Non-classified and Class 1 Div II stand-alone air fuel ratio systems.
-
Continuous monitoring systems to meet 40 CFR NESHAPS requirements.
-
Custom and standard ATS (Automatic Transfer Switch) systems.
-
Bus door ducts. (Indoor and Outdoor)
-
Explosion-proof main breakers and motor starters.
-
Solar panel powered battery charging systems.
-
AC powered battery charging systems.
-
UPS systems
-
Ignition systems for natural gas engine (non-classified and Class 1 Div. II)
-
Class 1 Div. II DC glow plug systems for diesel engines
-
Class 1 Div. II ignition harnesses and ignition lead assemblies
-
Magnetic pickup harnesses, governor actuator harnesses, and custom harnesses.